Lights and buttons · Lesson 2 of 5· 15 min

Wiring an LED

Why this matters

The built-in light is useful, but robots light up things you choose: a warning lamp, a status light. To do that you wire parts to the board's pins.

The parts

  • An LED has two legs. The longer one is the anode (A, the plus side). The shorter is the cathode (C, the minus side).
  • A resistor limits the current. Without one, an LED can burn out on a real board. We use 220 ohms.
  • A GPIO pin (General Purpose Input Output) is a pin you control from code. On the Pico they are named GP0, GP1 and so on.

Open a tool

Wokwi simulator

Free, nothing to install. Works best on a laptop; on a phone you can still read the steps and the code below.

Opens wokwi.com in a new tab. Come back here when you are done.

Open Wokwi simulator

Step by step

  1. In Wokwi, press the blue plus button and add an LED and a resistor.

  2. Click the resistor and set it to 220 ohms.

  3. Wire GP15 to one end of the resistor, the other end of the resistor to the LED's anode (A), and the LED's cathode (C) to a GND pin.

from machine import Pin
import time

lamp = Pin(15, Pin.OUT)

while True:
    lamp.value(1)   # on
    time.sleep(1)
    lamp.value(0)   # off
    time.sleep(1)

How the circuit works

Current flows out of GP15, through the resistor, through the LED, and back to GND. If the LED is in backwards, nothing lights: an LED only lets current flow one way. Try turning it round in Wokwi to see.

You’re reading for free. Sign in to save your progress, ask questions on any lesson, and earn a certificate when you finish.Sign in to keep my progress →

Lesson 2 of 5